MASTER BEDROOM

• Adjust the main lever for temperature.
• Pull the knob to turn on the water. (If water doesn’t come on, make sure the upper knob is also pulled out.)
• Use the smaller knob to switch between the main and lower showerheads, or a combination of both.
• Hint: To avoid the initial blast of cold water, make sure to point the smaller knob up, and rotate the main shower head towards the wall before turning on the water.

• Start filling the tub 10-15 minutes ahead of time.
• Fill the tub with water until it is 2 inches above the highest jets.
• Depress the button on the back edge of the tub to activate the jets.
• To add air bubbles, twist the knob next to the button. Opening the knob further creates more air bubbles.
• You may add provided bath salts if desired.
• Avoid using soaps, bubble bath, shampoo, or bath oil, or other products not specifically labeled for spa use. (You may use these products as long as you don’t activate the jets. )
• Note: The tub should be filled with your desired temperature water – it is not necessary to start with overly hot water.

The TV offers OTA channels as well as Roku. You can switch between the two devices using the input button on the main remote. The Roku remote only controls the Roku.

For detailed instructions on how to use the Roku, please visit the Roku TV section of the living room guide.

LEFT NIGHT TABLE

• Wireless charger built into surface of the table.
• Just center your device over the wireless charging symbol. When charging, the light on the front of the table turns green. (This charger does not work well with thicker cases)
• USB and 110 outlets are on front of table.

RIGHT NIGHT TABLE

• USB and 110 plugs are on front of table.

You should find at least one multi-end charging cord in the room.

DOOR:
Adjust the blinds by using the slider on the right side of the glass. Raise or lower the blinds to your desired height, then move the slider slowly in the opposite direction to change the angle of the slats.
WINDOW:
Using the tab in along the center bottom edge, just pull down or lift up to raise and lower the blind.